It has been there for a long time before I bought the hammer, and have been advised that it's likely not an issue. That's a materials and me problem, though, not the hammers. The rubber cushions are in pretty great shape, and now that I've tuned the hammer in some, it runs great when I'm not breaking belts. My setup works plenty well, but it's janky as all get out. The pulley arm and brake pad need to be re-done, though. You can see in the video that I have a bolt and nut in place of that lever on the sleve, so two wrenches and you're good. The brake pad, the original tightening assembly for the slip sleeve on the back, and tensioner pulley arm. It's complete, as far as the hammer itself is concerned, except for three things. I'm selling because I decided a pneumatic power hammer would fit my needs better.ġ50# Upright Strap Hammer.
The adjustable hydraulic flow reducer valve that is installed is the make/model that coal ironworks has recommended to me and was installed according to coal ironworks directions.
100 lb anvil for sale full#
And a adjustable hydraulic flow reducer valve is installed so you can adjust the speed of the ram/cylinder from anywhere between 0 inches per second to 4 inches per second, but will still have full power at any speed, and the adjustable hydraulic flow reducer valve can be easily removed to restore to the single speed of 4 inches per second as it was originally. Very lightly used coal ironworks upgraded 16+ ton hydraulic forging press for sale, less than 10 hours on it, comes with a set of H13 combination dies, a set of full width flat dies, a set of 4140 fuller/hammer trough dies, a stripper plate die for punching and a interchangeable socket die to interchange punches for punching hammers/axes/etc.
0 kommentar(er)
